Test Joint V1-Seba Dom

Im planning on doing a line of action figure only for 3D printing. I want you to help me test the first iteration of the joints.

The disk should feet inside the hinge and the 3 pegs should be popped in the 2 sockets( 3 pegs have different sizes so if you can please tell me which one fitter better for you and your printer).

If you dont understand this directions please see the image in the post or send me an email for further help and feedback. [email protected]

I printed this at 40 speed, PLA Makerparts Heat Bed 60 Nozzle 190 4 top, bottom and shell layers and 10 percent infill(having the 4 walls makes the infill almost not necessary but its my usual set up).

Hope you can help me!