"TetriDrawer" - The Modular Drawer System

Small, easy-to-print drawers.Two sizes for simple modular expansion.This system can easily be stacked on top of each other.The individual modules can also be fixed to the centres with adhesive to prevent them from slipping out of place.I use ‘UHU PLAST SPECIAL’ glue to bond PLA.UHU PLAST: https://amzn.eu/d/72nH6KZRubber feet (Ø6 x 2mm) can be fixed to the bottom of the drawers to prevent them from slipping on the table (see picture (1)).I have used these:https://amzn.eu/d/1pYyxnf(1)Assembly:To assemble the drawer, simply press the insert together slightly (as shown in the picture (2)) and slide it into the frame.The two knobs will snap into the rail in the frame and prevent the drawer from falling out.To remove the insert from the frame, simply press the sides of the drawer together again and pull it out.(2) In order for the studs to be movable, the support must be cut through once after printing. To do this, cut downwards once with the knife to cut the support layer (see the following