TEVO C270 Camera Mount

Update: I created a new mount that raises the camera 60mm higher. You can check it out here - https://www.thingiverse.com/thing:2457855

This is a quick and dirty Logitech C270 camera mount that I made for my Tevo Tarantula that is running on OctoPrint. I wanted something that allowed me to pose the camera, but was too lazy to design a ball/socket setup. I feel this will hold better in the long run anyway. It mounts on the left Z plate (original Tevo acrylic) and uses the two screws that hold the toothless pulleys. I was able to get it to fit with the existing screws. You also need a M4 x 10mm (or thereabouts) to assemble the camera bracket to the mount. An M3 x 16 or longer is needed to attach the camera to the bracket.

It may work with other models that have a similar camera housing. The hinge on this Logitech camera is 6mm wide and fits a 3mm pin (if that helps)

You will need to remove the existing clamp from the Logitech camera so that all you have left is the lens