Thingiverse
Tevo_endcap_Underframe
von Coat
33
Downloads
20
Likes
1
Makes
End caps for the Underframe of the Tevo Tornado. With a Tevo-logo for some extra bling. For printers of other brands and types (CR10?,Anet) with same frame-material there is a version without logo. Or customize your own cap with that one. I think these will also fit at the Tevo Tarantula.
From both there is a version with hard/sharp and soft edges. In each Stl-file there are two caps, one for the front-left and rear-right and one for the front-right and rear-left.
For similar endcaps for the upperframe see https://www.thingiverse.com/thing:2868596
Because this end cap has only support from two sides of the frame, the little "pillar" in the middle is the main part for a good fit. The 4.44 mm diameter-version (4p44 in filename) fits great at my printer (PLA and room-temperature). Due to different filaments and printers which will give a little difference, there are different versions with other diameters for the pillar in the zip-file: 4.36 to 4.48 mm (4p36, 4p40 and 4p48 in
From both there is a version with hard/sharp and soft edges. In each Stl-file there are two caps, one for the front-left and rear-right and one for the front-right and rear-left.
For similar endcaps for the upperframe see https://www.thingiverse.com/thing:2868596
Because this end cap has only support from two sides of the frame, the little "pillar" in the middle is the main part for a good fit. The 4.44 mm diameter-version (4p44 in filename) fits great at my printer (PLA and room-temperature). Due to different filaments and printers which will give a little difference, there are different versions with other diameters for the pillar in the zip-file: 4.36 to 4.48 mm (4p36, 4p40 and 4p48 in
Coat veröffentlicht auch auf
73 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
