Thingiverse
Tevo Flash stiffeners
von MKCAE
2
Downloads
0
Likes
0
Makes
Set of stiffeners for Tevo Flash
The design allows for setting the angle of the printer gate to the base.
A necessary parts of the set:
- M10 threaded rods (standard 535-540mm),
- 4 M10 nuts and 8 standard washers,
- 16 M5 screws, 10mm long,
- 16 M5 shims (optional).
NOTE: the fixing of the stiffeners makes it necessary to change the fixing of the front panel.
The design allows for setting the angle of the printer gate to the base.
A necessary parts of the set:
- M10 threaded rods (standard 535-540mm),
- 4 M10 nuts and 8 standard washers,
- 16 M5 screws, 10mm long,
- 16 M5 shims (optional).
NOTE: the fixing of the stiffeners makes it necessary to change the fixing of the front panel.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
