tevo nereus board relocation

i designed this because the tevo nereus robin nano board is placed pretty far back in the case and trying to install and remove the sd card is a real pain. so i came up with this.

it will move the motherboard 3 mm to the right and 4.5 mm forward. it removes the space for most people dropping the sd card into the machine.

this is not the most secure since it does not screw into the original mounting points (since if i did choose to screw it in, it would raise the motherboard too high to be able to access the usb port). The holes that go over the original stand offs, for me, are tight enough and hold it securely, but you may wish to secure it with double sided tape. i made some spots recessed by 0.5mm on this bracket to allow for some THIN double sided tape.

additionally i recommend adjusting your motherboard cooling 5 mm closer to the front. also, the stock wires should reach the minor adjustment (about 6mm from the original location)

print with 4 perimeters between 20-4