Thingiverse
TEVO_PSU_cover
von DoctorDave
23
Downloads
12
Likes
1
Makes
This thing was modeled after TevoPrinter's thing, except that I needed different front-end connections and I created a mount for the rear of the unit so the PSU rests level on the table. The covers were created for the S-300-12, the power supply which came with the Tevo Tarantula.
The main motherboard power lines are connected through the powerpole connectors, and the fans are connected through the 2.1x5.5mm connectors. When power is on, the green LED turn on. If the fans are not connected, the red LED turns on to warn that the electronics and the hotend heatsink are at risk of heating.
Using this thing allows one to totally disconnect the power supply from the 3Dprinter, and protects one from accidentally coming in contact with the power mains if wires are dislodged.
The main motherboard power lines are connected through the powerpole connectors, and the fans are connected through the 2.1x5.5mm connectors. When power is on, the green LED turn on. If the fans are not connected, the red LED turns on to warn that the electronics and the hotend heatsink are at risk of heating.
Using this thing allows one to totally disconnect the power supply from the 3Dprinter, and protects one from accidentally coming in contact with the power mains if wires are dislodged.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
