Tevo Tarantula Electronics Enclosure .case

This is case.
It is made for the Tevo Tarantula Board and 2 Mosfet.
It can be printed on the small Buildplate (200x200mm), so everyone can print and use it.
For the cooling fan there are three Options ranging from 40 to 80mm.

I know the Design can be al little cramped with all the Cables, but everything fits!
The Design is well tested and working. If you have any Problems getting all your cables through the Holes, you can cut out the middle parts, to get a bigger hole.

With the Mounting Holes on the Back, and the Side, you should have enough Options to mount your case to the Frame. There are Offset Brackets included as well.

What you need:
12x Motherboard Screws 9x5mm (4 for MKS Board and Mosfets each)
4x M4x6 for the Cover
4x Screws for the Fan, depending on your Fan Size.

You can use Brass Inserts If you like.

A 4mm Drill because the Screws are a tight fit!

*Update 02/23/2018*
Added a 70mm Fan Cover

*Update 01/06/2018*
Added a 92mm Fan Cover

*Update