Tevo Tarantula L bracket with ring

One of the things that leads to inaccuracy in printing is flex. The tarantula design doesn't really do much to help the Y axis flex on the 2 Z towers. There are a few designs out there for braces, but they all are rather short. So they'd help some, more on shorter prints but less on higher. Since i'm mounting the tarantula to a 2x2 foot board, I figure its nicer to use thin cable and a turnbuckle at each corner, or even GT2 belt and tensioner. This way it keeps stability from the top, its easier to adjust for the z towers to be level / perpendicular to the base plate, and the cables/belts can be mounted on the bottom end at the far corners of the board, keeping them more out of the way

I've included both a "standard" 5mm thick one, as well as a 7mm thick one in case you are concerned about stress on it.