Tevo Tornado Under Bed Standalone Kit

Standalone kit for Tevo Tornado

This kit allows mounting of the components from the Tevo Tornado control box and Raspberry Pi 3B+ or Pi4 under the bed and the screen on the front rail. It utilises two 6015 fans blowing downward directly onto the stepper drivers for cooling. The air is then directed out the side of the case and also through the PSU case for some cooling there.

Although the X and E stepper plus X-limit cables are on the short side and could be lengthened, no cables HAVE to be lengthened for this kit to be fitted.

The case lids are designed to be a snap on fit.

The design is optimised for printing at .2mm layer height and should not require supports.

The mains socket from the control box needs one of its mounting ears trimmed off to allow it to fit under the frame rail; see photo.

I printed the frame feet in a firm flex filament so that they are not totally rigid. You could print in a rigid filament and mount the original rubber feet to the bottom if