Thingiverse
TEVO TORNADO Z BRACKET
von infectedfpv26
542
Downloads
274
Likes
2
Makes
Here is the Z bracket for the stepper motor... there is a gap in one side of the stepper motor so its not completely flat on the frame... itps like 0.5mm gap so the stepper motor shaft has a deviation because of that..this bracket will solve that little issue.
U’ll need:
2x M5 TNUTS
2x M5 with 11.5mm length
2x M3 with 11.5mm length
2x M5 washer
U’ll need:
2x M5 TNUTS
2x M5 with 11.5mm length
2x M3 with 11.5mm length
2x M5 washer
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
