Thingiverse
TF2 Logo Keychain
door cdeox
24
Downloads
35
Likes
0
Makes
This is a TF2 logo keychain based on the r/place logo created on Reddit.
To get the multi colour I used the 'Change Filament at Z' Cura plugin. (https://www.thingiverse.com/thing:2077884)
My printer settings were 0.2mm layer height, 0.24mm layer width.
The layer count used to change filament is as follows:
0 - Black
6 - White
8 - White
10 - Orange
13 - Yellow
16 - White
You can check and use different layers in your slicer and update the colors accordingly.
Use infill greater than 40% to get good surface finish.
Feel free to use this however please give proper credit.
To get the multi colour I used the 'Change Filament at Z' Cura plugin. (https://www.thingiverse.com/thing:2077884)
My printer settings were 0.2mm layer height, 0.24mm layer width.
The layer count used to change filament is as follows:
0 - Black
6 - White
8 - White
10 - Orange
13 - Yellow
16 - White
You can check and use different layers in your slicer and update the colors accordingly.
Use infill greater than 40% to get good surface finish.
Feel free to use this however please give proper credit.
cdeox publiceert ook op
15 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
