Thingiverse

TFT-Display-Bezel

von ve7it

15 Downloads

7 Likes

0 Makes

This is a TFT display bezel that holds a "2.8 TFT SPI 240x320 V1.2" display on the front panel of a project panel. 4 machines screws hold the bezel on the panel with the display module trapped between the panel and the bezel. 4 clearance holds need to be drilled in your panel as well as a slot along 1 edge for the display connection plug. The display is held in the bezel by 4 posts that can have a blob of hot glue added after the display is installed. The display SD card slot is not used, but probably could be by adding a slot to the top of the bezel. The active display area of the LCD is not centered on the module board, but is centered in the bezel.The bezel could be made a little smaller, but the current size looked good on my panel. Full openscad source is included so you can change whatever you like. It would be easy to add a few LED indicator holes if you need them for your specific project. This project was derived from my previously posted dehumid-case. It is basically the top

240x320 320x240 arduino bezel esp32 lcd lcd display LCD Mount openscad scad SPI Display TFT Screen Touchscreen v12 240x320 320x240 arduino bezel esp32 lcd lcd display LCD Mount openscad scad SPI Display TFT Screen Touchscreen v12

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Warum?

aufwändige Nachbearbeitung

Einteilig Hardware nötig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 2/3

Drucker