TFT35 E3 case stand (Yet Another Ender3 Display Case)

While installing a rear electronics bay on my Ender3 Pro, I had the display hanging in the breeze. Afer a while, I grew to like it, so started looking for a case. Most were too big, busy, and overdone, also mounting electronics in it. I found one nice case, but it had a logo on it that I didn't care for. It also lacked a hole for the reset button on the TFT35. After a go at meshmixer, I got tired of the results so just decided to make my own.

This case holds just the display. My display is a tft35. The openings on the side for the USB and SD card are approximate. I didn't bother fine tuning them as I don't really use them. The attached files are my approximation based on a print. Good luck. Similarly, the reset button and the encoder shaft opening are a little off center and oversized. But at least I don't hit the reset if I press the face of the panel.

This should fit a stock display, but I didn't feel like digging mine out to double check. All of the designs for the stock displ