TGRI Lamp

This is a lamp that used a lot of online and freely available stl's but i cannot cite them all as the project was finished a long time ago. i only made the body of the lamp in tinker CAD. Then I decorated with the turtle accoutrement. The body allows for the sensor of those commonly purchased led ribbons to poke through into the helmet of shredder. the post is so you can look as many loops of the ribbon as you want without having to cut it. just wrap it end over end and run it though the hole in the base. the back is open for the led module. The canister cylinder was the inception for the project. The link for that specific clear tube as designed and printed was for this cylinder https://saeproducts.com/store/Clear-Gun-Tubes-GUN-GRN.html .To create the smokie look i used spray glue to stretch out cotton balls onto a 2 liter soda/pop bottle. i cut a sheet out from the bottle and used a sheet of paper as a diffuser, rolled these two together and into the main cylinder. after that its up