THC-S Soil Sensor Calibration & Grow Cube + Base

Recommended settings:0.2 Layer heightWall loops: 3Infill: gyroid or adaptive cubicInfill density: 15%Enable Support: Tree (auto)Support Style: Tree SlimThreshold angle: 30Supports on build plate only: trueSupport critical regions only: true I made this originally for the calibration of my THC-S Soil Sensor. When calibrating with the first version i noticed that after taking the sensor out and putting it back in, it was difficult to get reliable and good readings, because there was not way to compact the soil again. v2 has a slot that fits the sensor nicely and if needed there is a tool to gently pack the soil/coco before putting the sensor back in. i also made the walls 1.4mm thick, instead of 3mm to reduce print time. I find that with eSUN PLA+ it's pretty solid, but noticed with regular PLA the walls can crack if pushed too much. I wanted to avoid designing in a way that supports are needed, but i think this is the better way to do it. I printed with tree support for only critica