Thingiverse
The Agent lure
by RenMauPer
96
Downloads
68
Likes
0
Makes
A 10 cm topwater lure based on the Spook. Of course, I wasn't going to call it a Spook, so say hello to the Agent.
Print at 0.2 at 65% infill. The rest is fairly simple. I hope.
The design is simple (by which I mean "boring"), so if anyone can, feel free to spice it up with a remix.
Post a make if you do in fact make one.
UPDATE 11/04/2022
The new version is made in two halves with a cavity for the through wire, and another cavity in the rear for some 4mm steel ball bearings to serve as weights and/ or rattles. Haven't printed this one out and tested it yet, but when I do, I'm going to first try a 10% or 20% infill.
I've realized that, with this design, I can put the whole thing together using toothpicks in the alignment pin holes (no glue), and test out the appropriate number of steel balls. When I'm, satisfied, I can then glue it together.
Print at 0.2 at 65% infill. The rest is fairly simple. I hope.
The design is simple (by which I mean "boring"), so if anyone can, feel free to spice it up with a remix.
Post a make if you do in fact make one.
UPDATE 11/04/2022
The new version is made in two halves with a cavity for the through wire, and another cavity in the rear for some 4mm steel ball bearings to serve as weights and/ or rattles. Haven't printed this one out and tested it yet, but when I do, I'm going to first try a 10% or 20% infill.
I've realized that, with this design, I can put the whole thing together using toothpicks in the alignment pin holes (no glue), and test out the appropriate number of steel balls. When I'm, satisfied, I can then glue it together.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
