The Bee - Open Source Vape Mod

>###NOTICE
>I am not responsible for your use of this print, make sure it doesnt void your warranty, and make sure you are familiar with your printer.
>
>Any prints from me may require you to alter the scaling in your slicer depending on the shrink of the material/printer you are using.
>
>You need a 510 connector, keystone battery tabs, and a switch to fit in the hole.
>All of these can be found on ebay and I will not be linking anything for you.


If you are not aware of the dangers of batteries that can explode or catch fire if mishandled please leave this page now. Make sure before you attempt anything I have done that you are aware of Ohm’s Law as well as battery safety. I also highly recommend you use a mosfet and any other safety features you can. I implore you to do your own research before using any information seen here.

I started this project because I thought i saw a need I could satiate. I should start with a few facts about vaping and my experience so far. I s