The Bottle Butler

This was one of my first designs and prints and it takes care that an open bottle can’t tumble down. As minimalistic as it is… since I use it, there was no case anymore, where paints or solutions were spilled over my working desk. I can even left a long brush inside the bottle – no problem, it will not turn over. That’s why I call it the “Bottle Butler”!My design is made for Microscale bottles (I use it quite often for the fantastic decal softener, made by them) so inner diameter is 30mm. Sometimes I use nail vanish for my craftwork, so I made an inlet for these bottles (D=25mm) so I can use the same Bottle Butler for both kinds of bottles.You have bottles of different diameter? No problem… just scale up/done the Bottle Butler in your slicer software accordingly. Most slicer programs even give you the possibility to scale X/Y with different factors, than Z-axis. ;-)Have fun!Update: Added a square version for 7/8" x 7/8"-Testors/Pactra-bottles. Hope it works.