Thingiverse
The Can
von CookAndrewB
47
Downloads
20
Likes
0
Makes
I made this mech based on a hand-sculpted design I made for 6mm wargaming. I wanted to include it in my 28mm gaming world. I just call this thing "The Can" and it was my first shot at designing a mech in Tinkercad.
The figure in the picture is for scale only. The base is handmade and is not included in the print.
The mech does stand on its own but tends to be a bit back-heavy with the additional rocket pod. The canvas roll and the antenna are not part of the print. The canvas roll was added with Greenstuff epoxy, and the antenna is a piece of extruded PLA+.
I included a pre-sliced and supported version that I used for my AnyCubic Photon SE.
I have NOT test printed this in MDF, and you might want to chop it up if you were going to do so.
I may create an open hatched version in the future.
The figure in the picture is for scale only. The base is handmade and is not included in the print.
The mech does stand on its own but tends to be a bit back-heavy with the additional rocket pod. The canvas roll and the antenna are not part of the print. The canvas roll was added with Greenstuff epoxy, and the antenna is a piece of extruded PLA+.
I included a pre-sliced and supported version that I used for my AnyCubic Photon SE.
I have NOT test printed this in MDF, and you might want to chop it up if you were going to do so.
I may create an open hatched version in the future.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
