Thingiverse
The "Chaos" gyroscope
von psv6
27
Downloads
17
Likes
0
Makes
At the "Chaos" gyroscope, instead of the usual disk flywheel, I installed an asymmetric adjustable one. This fundamentally changes his behavior.
Bearings 2 pcs. 7mm.*3mm.*2.5mm.; 2 pcs. 10mm.*3mm.*4mm. 1 PC. 32mm.*12mm.*10mm..
Bronze rods 23mm.*12.5mm. (can be replaced with furniture handles) with an M3 hole and a bolt.
Metal rectangular plate 41mm.*8mm.*2mm. with two holes at the edges at a distance of 40.5 mm. and one in the center 1.5mm.
3 pcs. metal tubes 95mm.*4mm.
https://www.youtube.com/watch?v=JAmnl1YGE1k
Bearings 2 pcs. 7mm.*3mm.*2.5mm.; 2 pcs. 10mm.*3mm.*4mm. 1 PC. 32mm.*12mm.*10mm..
Bronze rods 23mm.*12.5mm. (can be replaced with furniture handles) with an M3 hole and a bolt.
Metal rectangular plate 41mm.*8mm.*2mm. with two holes at the edges at a distance of 40.5 mm. and one in the center 1.5mm.
3 pcs. metal tubes 95mm.*4mm.
https://www.youtube.com/watch?v=JAmnl1YGE1k
psv6 veröffentlicht auch auf
18 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
