Thingiverse
The Egg - 3D Printed Speaker
von ARTuino
51
Downloads
48
Likes
0
Makes
This is a speaker created in collaboration with HiFiBerry, Beocreate during the course 41030 Design of Mechatronics at The Technical University of Denmark DTU.
The speaker was entirely 3D-printed on a Zortrax M200 printer using Ivory Zortrax Z-Ultrat filament.
As the files might indicate, the speaker is comprised of five parts to complete the shell, as well as two conical reflectors to spread the sound. A full assembly guide, as well as a walkthrough of the entire design process, can be found using following link:
https://artuinoblog.wordpress.com/2017/04/05/guidance-to-replicating-the-design/
(And yes, the rye bread is intentional)
The speaker was entirely 3D-printed on a Zortrax M200 printer using Ivory Zortrax Z-Ultrat filament.
As the files might indicate, the speaker is comprised of five parts to complete the shell, as well as two conical reflectors to spread the sound. A full assembly guide, as well as a walkthrough of the entire design process, can be found using following link:
https://artuinoblog.wordpress.com/2017/04/05/guidance-to-replicating-the-design/
(And yes, the rye bread is intentional)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
