Thingiverse
The Jefferson Memorial
door jonbourg
59
Downloads
32
Likes
1
Makes
The Jefferson Memorial in Washington DC
UPDATE: 20190519 Printed out and I didn't like the scaling. Increased in size 75%. If you scale it down don't go any further than 25% smaller or the columns will be too small.
UPDATE: 20190518 When I made this model it was for a flight simulator program and I had to make the model less than 500k.
I wanted to make this easier to print on a 3D printer so I have reworked it to make it higher resolution. I've split the model into 4 parts 3 parts should print without support, but the dome will likely need support. I would recommend gluing the building parts 1 & 2 together and leave the base and dome unglued.
When I get the chance I will add a suitable model of the Statue of Thomas Jefferson that resides in the middle of the memorial.
The original version is still included.
UPDATE: 20190519 Printed out and I didn't like the scaling. Increased in size 75%. If you scale it down don't go any further than 25% smaller or the columns will be too small.
UPDATE: 20190518 When I made this model it was for a flight simulator program and I had to make the model less than 500k.
I wanted to make this easier to print on a 3D printer so I have reworked it to make it higher resolution. I've split the model into 4 parts 3 parts should print without support, but the dome will likely need support. I would recommend gluing the building parts 1 & 2 together and leave the base and dome unglued.
When I get the chance I will add a suitable model of the Statue of Thomas Jefferson that resides in the middle of the memorial.
The original version is still included.
jonbourg publiceert ook op
5 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!