Thingiverse

The Jenga Toothpick

by Dave_C_FPV

89 Downloads

100 Likes

0 Makes

This new 3" inch toothpick design is pretty experimental and the result of me playing around in my CAD. It's made out of four identical cheap 2mm plates that can easily be replaced. I wasn't sure whether I want to put it up here on Thingiverse because I don't see that many advantages compared to my [Sanchez](https://www.thingiverse.com/thing:3647138) frame while it is slightly heavier (9g vs 7.5) and a bit less stiff. But since my of you liked the looks I still uploaded it!

Key facts:
- 3 Inch true x
- 9g without hardware
- 9mm four-hole motor mounts
- AIO and 16x16 mounts: If you use an AIO make sure to secure the 16x16 holes with M2x6 and some nuts. If you use a 16x16 plase use steel screws (no nylon!)

Build recommendations: Since this frame is not as stiff as the Sanchez super big 1404 motors will be possibly hard to tune. Better go for light 1103-1105.

My personal light 2S Setup:
======================
- Motors: [T-Motor F10](https://www.banggood.com/custlink/mm3vZI

drone fpv jenga kabab toothpick mini quad miniquad Quadcopter Frame tiny whoop toothpick toothpick fpv whoop drone fpv jenga kabab toothpick mini quad miniquad Quadcopter Frame tiny whoop toothpick toothpick fpv whoop

Source

Thingiverse

What you need to print this: Intermediate Low confidence

Single piece Hardware needed

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 1/3

Printer

FDM / FFF

File format