The Mack Rack

Hi everyone! This is my first thing and I'm glad to share it with everyone! This is a rack I made to hold my 3 pistols, a Beretta 92FS (9mm), a Bersa Thunder 380 Plus (.380), and a SCCY CPX-3 (.380). The rack will hold medium sized pistols and I'm sure most full sized pistols. My full sized beretta fits but it does take up most of the room from front to back so don't expect your Colt Python or Desert Eagle hand cannons to fit lol. Measurements from front to back are 205mm. The magazine holder was made specifically to hold my magazines so as far as the ability to hold other sized mags I could not say for sure. The measurements for the left 3 mag holders as well as the top right mag holder measure 21x28 and hold my .380 mags. The two bottom right mag holders are measured 22.5x32.5mm to hold the 9mm mags. I needed a raft to print the rails as to prevent them from being knocked over, also the rails need supports as I printed them vertically because my Ender 3 is giving me minor inconsisten