Thingiverse
The Mug Jug
von scholtzap
8
Downloads
12
Likes
0
Makes
Made this climbing hold crimp for a cup as an interesting gift.
I bought a cheap mug (70 mm diameter) and used a diamond blade grinder to remove the handle that was on it. Then I attached the printed model using Prattley's Putty - a strong two-part clear adhesive (temperature rated to 95 degC.)
I didn't have any alley key bolts lying around so I cut the head off a big screw and stuck it on for a bit cooler look. Didn't have time to source a proper bolt, unfortunately.
I bought a cheap mug (70 mm diameter) and used a diamond blade grinder to remove the handle that was on it. Then I attached the printed model using Prattley's Putty - a strong two-part clear adhesive (temperature rated to 95 degC.)
I didn't have any alley key bolts lying around so I cut the head off a big screw and stuck it on for a bit cooler look. Didn't have time to source a proper bolt, unfortunately.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
