The Plaster Plaster - Wall, Ceiling Repair

The Plaster Plaster! Got a jiggered wall or ceiling? need some extra support? Screw in a Plaster Plaster. Let's get the first thing out the way… You can often use Joint Tape, sure, your wall or ceiling or drywall might be so far gone you'd be better to board over it or pull it down and replace it. But before you do all that if you're experienced, you might know exactly where and how this print might be useful - to give extra support. Why? The big difference over tape here is the ability to screw into place to tie up cracks and add extra support. The holes will allow the plaster to penetrate the board and bind the plaster to the wall. How to use:Print (PLA is fine)Splash some PVA glue on the backSlap it on the way.Screw if necessary.Knife off any protrusions that would stop you covering over it and getting the depth you need. (See Pics)Considerations: You need about ~1.7mm of plaster depth to use this. Get some low profile screws if screwing. Boost MeIf this helped you, plea