The Sinkbuster!

This is a levitation device for your sink. What I mean is, if you a have a sink with a ridge that is much lower than the sink level, say in a split sink, you can use this to lift up a pot or pan while you clean it, so all the water doesn't run out.

You may want to modify it for your sink using the scale() command in OpenSCAD. I used that and Meshmixer to build this.

I used Polymaker Smooth PLA to print it coz I wanted the services smooth with no print line artifacts. Worked great.

3/14/2021 - Added another design which also works great. Is a little shorter if you want that. It also 'reclines' the handle support a bit further into the secondary sink, which is needed by my big Lodge pan.