Thingiverse
The slim wallet
von Sethbergman
0
Downloads
0
Likes
0
Makes
this wallet is a remix of penlands design.
holds 2 id cards plus 7 cards in the main compartment
Print in place wallet I designed. Holds up to 9 cards inside, requires no supports and prints standing up.
On the top side there is a locking mechanism, down is lock, up is unlock.
On the bottom, there is a lever you push to make the cards come out.
After finishing printing, remove the built in support from the locking mechanism on the top side. Next, push the leaver at the bottom through the hole to help it get unstuck.
This model requires high tolerances
holds 2 id cards plus 7 cards in the main compartment
Print in place wallet I designed. Holds up to 9 cards inside, requires no supports and prints standing up.
On the top side there is a locking mechanism, down is lock, up is unlock.
On the bottom, there is a lever you push to make the cards come out.
After finishing printing, remove the built in support from the locking mechanism on the top side. Next, push the leaver at the bottom through the hole to help it get unstuck.
This model requires high tolerances
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
