The Sprool

This roller puts your spool only a few millimeters above the surface, while at the same time allowing you to mount it from above. This makes it ideal for putting spools inside an enclosed printer. Adjustable for smaller spools.

Using it inside your Flashforge Creator Pro? Go ahead and print [this](https://www.thingiverse.com/thing:6355843) as well.

The roll comes in two versions; one that requires support and one that requires a separate peg. I'd highly recommend the former if you have a dual extruder. You could of course try your luck using ordinary supports as well but I'm way too lazy for that.

You'll probably be fine without reading the rest (except the important note in Print Settings).
####Why I made this
I have my Flashforge Creator Pro in a sort of closet, which makes its back very hard to reach and there's no room for filament next to it. However, I noticed there was a lot of space on the sides of the bed and thought, "Surely that can't be enough to fit an entire sp