Thingiverse
THE Surface Pro Stand
por kieranh45
5
Descargas
6
Likes
0
Makes
I needed a larger print to test some filament and I needed a tidier, reliable stand to store my surface pro on the desk. So I made the THE Surface Pro Stand.
The wide base means I haven't had to worry about kocking it over.
Most slim laptops and tablets should fit in no worries but a Surface Pro with cover should feel just right.
Layer Height: 0.2 mm
Material: All, PLA recommended
Infill: 10%
Infill Parttern: Pay close attention to your slice on the internal chamfers. A hex pattern can result in holes on the top surface due to being unsupported. Linear pattern recommended.
The wide base means I haven't had to worry about kocking it over.
Most slim laptops and tablets should fit in no worries but a Surface Pro with cover should feel just right.
Layer Height: 0.2 mm
Material: All, PLA recommended
Infill: 10%
Infill Parttern: Pay close attention to your slice on the internal chamfers. A hex pattern can result in holes on the top surface due to being unsupported. Linear pattern recommended.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
