Thingiverse
The Thinker Bookend
von bhty
995
Downloads
870
Likes
11
Makes
I needed bookends for my shelves. After digging around I didn't find anything that suits my needs just right.
However I found this awesome model of "The Thinker": https://www.thingiverse.com/thing:2164071
So I grabbed the "Lowest_poly_thinker_easier_to_print" model and started to modify it and here is what I came up with.
For my printing I used 0.2 mm layer height and no infill. Still if you want to have some infill anything in between 5%-20% should work just fine.
However I found this awesome model of "The Thinker": https://www.thingiverse.com/thing:2164071
So I grabbed the "Lowest_poly_thinker_easier_to_print" model and started to modify it and here is what I came up with.
For my printing I used 0.2 mm layer height and no infill. Still if you want to have some infill anything in between 5%-20% should work just fine.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
