Thingiverse
The Trapper's Cleaver
von PinnacleProps
154
Downloads
134
Likes
3
Makes
This is The Trapper's Cleaver from the popular video game "Dead By Daylight".
I found this as a game rip file from somewhere (not sure where) a long time ago and decided I would like to print it so I scaled it to size and sliced it up.
NOTE:
I will be using ABS to print this with so I can use an ABS slurry to bond it and make it stronger because of the beatings it will endure during cosplay.
I dont reccomend PLA unless its just going to sit there.
Also, i would print as vertically as you can to avoid using supports as much.
other than that, GOODLUCK!
I found this as a game rip file from somewhere (not sure where) a long time ago and decided I would like to print it so I scaled it to size and sliced it up.
NOTE:
I will be using ABS to print this with so I can use an ABS slurry to bond it and make it stronger because of the beatings it will endure during cosplay.
I dont reccomend PLA unless its just going to sit there.
Also, i would print as vertically as you can to avoid using supports as much.
other than that, GOODLUCK!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
