Thingiverse

thermal detonator class-A

by Juli_1905

31 Downloads

16 Likes

0 Makes

First of all you have to install 4 3mm LEDs inside the button and the three holes.
After some cleanup the button should slide smooth throught the hole.
Then you have to install a small pushbutton underneath the button and fix it inplace inside of the thermaldetonator.
After wireing everything up you need to glue some magnets on to the inside edge(you could also glue the two halfs permanently in place if you don´t need anymore acess).

I powered the whole thing with a 9V blockbattery and used a cheap china arduino nano clone.

arduino Arduino Nano cosplay prop costume prop diy electronics explosive game props hansolo Movie Prop prop props Simple print starwars star wars thermaldetonator arduino Arduino Nano cosplay prop costume prop diy electronics explosive game props hansolo Movie Prop prop props Simple print starwars star wars thermaldetonator

Source

Thingiverse

What you need to print this: Advanced Low confidence

Why?

very large print · significant post-processing

Single piece Hardware needed May need scaling or splitting

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 3/3

Post-process 3/3

Printer

FDM / FFF

File format

STL

Material

PLA

Min. bed size

300 mm (Extra large)

Post-processing

Sanding, Gluing, Hardware

Software

Cura, PrusaSlicer, or similar

No ratings yet

No comments yet – be the first!

Similar Models

4 Suggestions

thermal detonator class-A

Similar Models

Add to Collection