Thingiverse
Thermal printer roll holder
by CuriousTech
40
Downloads
50
Likes
0
Makes
Snap on / sliding label roll holder.
HolderRoller has a print-in-place 45 degree stop hinge.
NEW: Try this one first:
HolderBearingShort Has a smaller rod part that fits Dymo rolls, and has a pin for a 608ZZ bearing (print with support touching buildplate).
HolderCradle is for a rod.
These are the right side only. Flip in slicer for left side.
I printed with PLA, 0.2 layer height. The half-spool doesn't fold completely horizontal, but it might over time. It seems to be holding up for the first day.
HolderRoller has a print-in-place 45 degree stop hinge.
NEW: Try this one first:
HolderBearingShort Has a smaller rod part that fits Dymo rolls, and has a pin for a 608ZZ bearing (print with support touching buildplate).
HolderCradle is for a rod.
These are the right side only. Flip in slicer for left side.
I printed with PLA, 0.2 layer height. The half-spool doesn't fold completely horizontal, but it might over time. It seems to be holding up for the first day.
CuriousTech also publishes on
7 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
