Thermobox for FlyingBear Ghost 5

upd 2/10/23
added door holders. They are fixed with the screws of the bottom cover, the screws should be replaced with longer ones.
The material of the door is the same as that of the cap (but now 8mm! or mod), the side vertical edges are plugged with a U-profile. Between the cap and the door in the upper corners to push a magnet (10x1, 12x1, etc). I have 10x1. Coaxially to them on the frame of the printer glue a couple more, I have 2 pcs 10x1.

++++++++++++++++++++++

Housing is made from cellular polycarbonate panel. In my case 8mm, but it is not crucial. All edges are muffled by the U Section Sheet profile. The wide part of the U Section Sheet should be oriented outside the box.
Details should be located on the bed in such a way that one of the holes for M4 bolt (the one that is muffled in the model) is horizontal. It will allow to print without support.

Assembly. You need to cut top corners of the panels slightly until the they allow the walls to dock. Places for tighte