Thin cable duct for under desk

I created this cable duct because of the cables of my joysticks, because their cables were hanging under the table and the armrest of the chair kept hitting the cables and tearing them out. To protect the cables from the armrest of the chair, I printed this cable duct, where the cable from the VKB Gladiator NXT fits very well and additionally the cable from the Stream Deck, which was also mounted under the table.Depending on your needs, you can either screw it on or use 3M double-sided adhesive, which is a little thicker than 1 mm to provide sufficient hold. There is also an extra 1 mm deep recess for this, so that the adhesive still has sufficient hold but also sinks deep enough so that the cable duct does not stick out.Maybe one or the other also has exactly the same problem and is happy about this solution.