Thingiverse
Thin Knob
von tmt0727
3
Downloads
3
Likes
0
Makes
I have this knob and Z-Axis Bearing Stabilizers installed
Z-Axis Bearing Stabilizers
https://www.thingiverse.com/thing:3370355
Everything was fine until I tried to print a very tall STL
134.1 x 82.0 x 244.0 mm
This knob did hit the stabilizer and the print was stopped at the almost the end, so I made a thinner one and will cut the stabilizer by a hot knife instead of re-print.
Z-Axis Bearing Stabilizers
https://www.thingiverse.com/thing:3370355
Everything was fine until I tried to print a very tall STL
134.1 x 82.0 x 244.0 mm
This knob did hit the stabilizer and the print was stopped at the almost the end, so I made a thinner one and will cut the stabilizer by a hot knife instead of re-print.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!