Thingiverse
Thinkpad x200 Tablet Hinge Cover
von Gigahawk
3
Downloads
1
Likes
0
Makes
The hinge cover for my x200 tablet broke so I decided to make a new one.
This model lacks the slight taper that the original one has towards the top, but it makes it easier to print and you can sand you own taper in after if you so choose. I am reasonably sure this is the exact same stl that is currently in my personal computer but if you're scared of wasting filament I recommend lowering the width of the nubs on the inside.
The Half Narrow model slightly flares out at the front, while the Narrow model does not flare out. In practice this should not make a difference but if you have particularly flexible filaments you may want to use the Narrow one.
This model lacks the slight taper that the original one has towards the top, but it makes it easier to print and you can sand you own taper in after if you so choose. I am reasonably sure this is the exact same stl that is currently in my personal computer but if you're scared of wasting filament I recommend lowering the width of the nubs on the inside.
The Half Narrow model slightly flares out at the front, while the Narrow model does not flare out. In practice this should not make a difference but if you have particularly flexible filaments you may want to use the Narrow one.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
