Thinkware F770 Dashcam Mount

This is a holder for Thinkware's now deprecated F770 Dashcam front unit. Getting ahold of an additional mount is near impossible, so I created my own ...

Removing support material underneath the locking extensions requires some fiddling, but in general should work... I might try to add my own support strut on just one side and use bridging, but for now the model generated fits pretty well.

Make sure you print with something that will be able to take the heat of the sun, PLA will most likely not survive direct sunlight in the summer ;)

Thanks to the folks at https://maglab.space for doing the print on their printers, as I don't yet own a 3D Printer ...

The little clips going into the dashcam will need some support, even with good cooling. Cura creates some pretty decent, removable support, but I will probably add a manual support structure to just allow for the short bridging.