Thingiverse
Thor Hammer Keychain
por timmy_d3
3.3k
Descargas
2.9k
Likes
30
Makes
UPDATE: Check out my updated and more print-friendly version of the design at https://www.thingiverse.com/thing:4240269
This is a basic keychain of Thor's hammer (Mjolnir). It's a normal size for a keychain, though it still has good strength and durability.
I would recommend printing it sideways with the Asgard emblem facing up. Print with supports for the handle, as it will start about halfway through the print. I did mine with 30 percent infill and 0.1mm layer height. No raft.
For paint I just used metallic silver spray paint and a non-gloss brown enamel spray paint. I used painters tape to separate segments, no hand painting needed.
Hope y'all enjoy. Please share pictures if you make on!
This is a basic keychain of Thor's hammer (Mjolnir). It's a normal size for a keychain, though it still has good strength and durability.
I would recommend printing it sideways with the Asgard emblem facing up. Print with supports for the handle, as it will start about halfway through the print. I did mine with 30 percent infill and 0.1mm layer height. No raft.
For paint I just used metallic silver spray paint and a non-gloss brown enamel spray paint. I used painters tape to separate segments, no hand painting needed.
Hope y'all enjoy. Please share pictures if you make on!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
