Thingiverse
Thor - Open Source, 3D printable Robotic Arm
door AngelLM
5.6k
Downloads
5.4k
Likes
4
Makes
**Important Note**: I suggest you to go to [Thor's Website](http://thor.angel-lm.com/) or [Thor GitHub Repository](https://github.com/AngelLM/Thor) in order to download the latest version!
<hr/>
**Thor** is an Open Source and printable robot arm with six degrees of freedom.
Its configuration (yaw-roll-roll-yaw-roll-yaw) is the same used by most of the manipulator robots on the market. In its extended position, Thor is about 625mm high and can lift loads up to 750 grams.
The project started in 2015 as a final degree project called “Design and impplementation of an Open Source, 3D printed 6DOF robotic arm”. Since then, this project has continued to develop little by little.
The main purpose of this project was to design a robot that could be used in universities and schools to teach robotics.With this in mind, the design had to be affordable and accessible. Releasing the source files and doing so under an open source licence was the best option: anyone could study any
<hr/>
**Thor** is an Open Source and printable robot arm with six degrees of freedom.
Its configuration (yaw-roll-roll-yaw-roll-yaw) is the same used by most of the manipulator robots on the market. In its extended position, Thor is about 625mm high and can lift loads up to 750 grams.
The project started in 2015 as a final degree project called “Design and impplementation of an Open Source, 3D printed 6DOF robotic arm”. Since then, this project has continued to develop little by little.
The main purpose of this project was to design a robot that could be used in universities and schools to teach robotics.With this in mind, the design had to be affordable and accessible. Releasing the source files and doing so under an open source licence was the best option: anyone could study any
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
