Thingiverse
Thors Hammer
por Jubaz
133
Descargas
114
Likes
4
Makes
---- Thors Hammer ----
I tried to make a "Thors Hammer" for my kid, I think it came out well enough to share.
I sliced it with Simplify3D
The Endcap I printed in 0.20 (infill 100% and Support)
The Shaft in 0.24 (infill 40%)
The Head in 0.24 (infill 50% in bottom where the threads are, 10% in the middle, and 40% from a few layers before the top layers start)
This is just how I printed mine, just make sure to have enough infill around the threads and in the top.
NB. If you are unable to lift the hammer after printing, you are not worthy ;-)
See my other things HERE
I tried to make a "Thors Hammer" for my kid, I think it came out well enough to share.
I sliced it with Simplify3D
The Endcap I printed in 0.20 (infill 100% and Support)
The Shaft in 0.24 (infill 40%)
The Head in 0.24 (infill 50% in bottom where the threads are, 10% in the middle, and 40% from a few layers before the top layers start)
This is just how I printed mine, just make sure to have enough infill around the threads and in the top.
NB. If you are unable to lift the hammer after printing, you are not worthy ;-)
See my other things HERE
Jubaz también publica en
17 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
