Thingiverse
Thrasher Flag Holder
von elknerps
2
Downloads
2
Likes
0
Makes
Flag Holder for a Thrasher Jet Boat.
I have tested this on a couple hard runs and the flag stays on really well now. I used silicone tubing at the bottom so when it rolls over or hits something from above it just bends and pops right back up.
I have tested this on a couple hard runs and the flag stays on really well now. I used silicone tubing at the bottom so when it rolls over or hits something from above it just bends and pops right back up.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!