Thread Cleaner Case, fits Lang Tools 2584

This is a folding case for the Lang 2584 metric thread chaser set. use the v4 latch if you have clearance issues, or scale it up in one direction to open it up if you cant get it to slide over the mechanism, it should move freely but have a bit of friction to keep it closed.

Print the lid letter side down.

print the latch with a brim or raft if you have bed adhesion issues as its very small.

The tool tray should press fit into the bottom half of the case.

I used small machine screws and a nut for the hinges, but you may not need a nut. you could also use some thick stiff wire for the hinge.

Supports are needed for the hinges and latches. not needed for the lettering but it wont hurt either way.