Thread Die Holder

Convenient holder for thread cutter dies.

Requires up to eight M3 x 10 mm screws and nuts. Pull the nuts radially into thir hex recess with the help of the screws (nut with flat side up, see cutaway 3D drawing).

====================================================================

Update 5 August 2023:

I broke the previous holder while cutting mild steel because I had printed it with only 2 peripheral/loop and 2 top/bottom layers. Further, the vertical insertion of the nuts proved problematic in that some nuts turned freely after their seat was damaged during forceful insertion of the nut.

So I redesigned the holder for radial insertion of the nuts into a tight hex recess and printed it with 4 peripheral/loop and 3 top/bottom layers. Hope this helps.

Update 21 July 2023:

- Added slots between die and nuts. While dismounting, you can now observe which screws are still enganged and which are not (see picture #2).

Update 15 July 2023:

- Eight instead of two mou