Thingiverse
Thread tapping tool guide
door Thosam
45
Downloads
22
Likes
2
Makes
When building the D-Bot CoreXY 3Dprinter by spauda01 (http://www.thingiverse.com/thing:1001065), you need to tap M5 theads into several V-slots.
To help me keep the tapping tool centered and vertical, I designed this little tool guide that slides on top of the 2040 Vslot ends where needed.
Designed for an M5 thread tapping tool with less than 6 mm diameter, will work with similar tools of similar diameters.
To help me keep the tapping tool centered and vertical, I designed this little tool guide that slides on top of the 2040 Vslot ends where needed.
Designed for an M5 thread tapping tool with less than 6 mm diameter, will work with similar tools of similar diameters.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
