Thingiverse
Threadable CR2032 Battery Holder
door Oana
442
Downloads
338
Likes
3
Makes
I made this to go with my [Star Projector](http://www.thingiverse.com/thing:509174, "Star Projector - Canis Major").
I wanted a design I could glue down on one side, and attach an LED to on the other side, so I made this threadable CR2032 battery holder based on [NotSoSolid's Design](http://www.thingiverse.com/thing:48606, "NotSoSolid's 2032 Battery Holder"), to which I did a complete remodel to get the topology doing what I needed it to.
After the first accident where I couldn't get the battery out, I've added a rectangular escape hole, the battery sits very snugly in there.
You will need a little bit of wire to thread the electronics through.
There's also an indent for a very faint 4-pin LED, but you can ignore that if you wish :)
I wanted a design I could glue down on one side, and attach an LED to on the other side, so I made this threadable CR2032 battery holder based on [NotSoSolid's Design](http://www.thingiverse.com/thing:48606, "NotSoSolid's 2032 Battery Holder"), to which I did a complete remodel to get the topology doing what I needed it to.
After the first accident where I couldn't get the battery out, I've added a rectangular escape hole, the battery sits very snugly in there.
You will need a little bit of wire to thread the electronics through.
There's also an indent for a very faint 4-pin LED, but you can ignore that if you wish :)
Oana publiceert ook op
6 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
