Threaded Hollow Egg shaped container.

I drew this in fusion 360. The 3mf is about the size of a real egg. I extruded a flat spot on the bottom so they’ll sit on there own. It is threaded in the middle and hollow to put things in. I printed some at 150% and 200%. Two normal size eggs will fit into a 200% model. Its a little tight feeling at first when screwing them together but don't worry. Just go back and forth at little increments. It will free up and thread easily. Also I had to add supports but they're in the bottom half holding up the inside lip that the threads are on. They're really easy to remove and even if they left a scar you won't see it because of where it is. But I don't feel a scar and since they come off so well this is not an issue. Scale up or down. Like I said this 3mf is the size of a normal egg. I printed at 150% and 200% just fine. I will include a picture. i used adaptive layering at the top so it prints really clean. Kids will love hiding little trinkets in them. Hope you enjoy.