Threaded Multicolored Die (Beta)

Beta Note This is a first “beta” version. It works but the print - especially of the sides is not so nice yet. I plan on refining this further and then release the source files to make remixing sides easier. “Bugs” in the current design that I plan to fix/add first: Alignment / angle of screwed on sides sometimes is off (e.g. the 3 dots are not on the diagonal of the side)Once side is screwed in, it is very hard to take it offThe sides edge is too thin, that makes dots in the corners not so readableThe sides edge is too thin, that makes it hard to get them off the build plate without breakingNon-AMS colored version with deeper insets to allow manual filament change after layer 2 and 4 (and likely also for faster AMS prints.Stay tuned for updates on the modelBoost MeA boost would greatly motivate me making the next version ;-)Description: After modelling a multicolored die and noticing that it would easily need 100+ filament changes I looked at different things Makerworld had to offer a